ATTACHING WALKER BUDDEZZ™ TO YOUR WALKERS

Step 1.

Disassemble WALKER BUDDEZZ™ guide unit by first removing the nylon glide, followed by separating the foam liner from the plastic boot (located in the center of foam liner).

Step 2.

Split the plastic boot into two pieces and line up around bare pole or plastic cap component as shown in
picture to the right .

Step 3.

After lining the two separate boot pieces around the walker peg leg and/or mushroom cap press the two pieces together.

NOTE: Boot pieces should snap easily and should be
guided by the groves within the inner boot
surface.

Step 4.

Once the boot is secured press the foam liner onto the boot (smaller hole of the foam liner first).

Step 5.

Complete by pressing the nylon glide onto the bottom of boot and foam liner. Make sure the device is secure on the walker leg and enjoy.

PERSONALIZING MOBILITY DEVICES